Our Products

Used to Check O.D. 2 Jet, Centre/Offset we can 3 Jet to check lobbing effect Multi-level Jet we can Suitable will any make AGU Range: 6 to 230 mm in Steel 10 to 45 mm in Carbide

M1A: For Ø 6mm to 200mm. M2A: For Ø 1.5mm to 6mm Accuracy ± 2% FSD Pressure 4.5 bars

Used to Check I.D. 2 Jet, Centre/Offset we can 3 Jet to check lobbing effect Multi-level Jet we can Suitable will any make AGU Range: 3 to 200 mm in Steel 10 to 45 mm in Carbide

Microprocessor based Unit Scaling factor L.C. 5µm, 1 µm, 0.5 µm, 0.1 µm Bar graph can be adjusted Tricolour LED display showing Accept, Reject & Rework Buzzer for rejected job

Microprocessor based Unit Scaling factor L.C. 5µm, 1 µm, 0.5 µm, 0.1 µm Bar graph can be adjusted Tricolour LED display showing Accept, Reject & Rework Buzzer for rejected job

To Check interrupted shaft “V” Support for stability 2 Jet, Centre/Corner we can Multi-Jet to check crowning Suitable will any make AGU Range: 8 to 240mm in Carbide

For Taper, Major & Minor Ø Gauge plane Ø can check +/-20u, 0.5 um Taper Air Ring Gauge Taper Air Plug Gauge

Microprocessor based Unit Scaling factor L.C. 5µm, 1 µm, 0.5 µm, 0.1 µm Bar graph can be adjusted Tricolour LED display showing Accept, Reject & Rework Buzzer for rejected job

Microprocessor based Unit Scaling factor L.C. 5µm, 1 µm, 0.5 µm, 0.1 µm Bar graph can be adjusted Tricolour LED display showing Accept, Reject & Rework Buzzer for rejected job